FAQ

The time required to charge a 100% battery is approximately 3-10 hours under ideal conditions. Charging time may vary depending on the type of battery and charger used and the input current.

added 16. 06. 2023

The front turning radius of MiniZ is 1500 mm and the rear turning radius is 800 mm.

added 08. 10. 2021

The machine offers 2 operational speeds. The minimum speed is 0,1 km/h, which can be smoothly increased up to the maximum speed of 5 km/h.

added 08. 10. 2021

MiniZ can manipulate with a load of 400kg up to 2070mm high.

added 08. 10. 2021

The MiniZ was designed to operate mainly with the supplied Danfoss remote control, with the newly added option of emergency control of the machine by phone via bluetooth. The remote control is designed to be attached to the machine.

added 16. 06. 2023

Periodic service will be performed by a service technician every 500 operating hours. This includes a complete check of bolt and screw tightness, transmission oil change, hydraulic filter replacement. and other maintenence. The complete list of steps can be found in the user manual.

added 08. 10. 2021

For changing the hydraulic filter the interval is 500 mh and for changing the hydraulic oil the interval is 1500 mh. For gear oil, the first interval is 50 mh and subsequent intervals are every 500 mh.

added 16. 06. 2023

A general examination should be performed ever 10 operating hours, where you should examine the greasing of the pins, the visual condition of the machine and the level of electroylte in the accumulator. The complete list of steps can be found in the user manual.

added 08. 10. 2021

You can easily find the charging connector by lifting the upper service hatch.

added 08. 10. 2021

MiniZ is equipped with 3 IPM120 electric motors, two of which control the movement of the machine, while the other powers the hydraulic pump.

added 08. 10. 2021

The working pressure of the system is 180 bar, while the working flow is 65 l/min. The hydraulic tank capacity is 30 l.

added 08. 10. 2021